Wolfgang Schulze-Zachau demonstration June 2017

Wolfgang Schulze-Zachau demonstration June 2017

                                                                                                                                          

 Blackcountry woodturner member, Wolfgang Schulze-Zachau, gave the June meeting demonstration. During the evening, he covered a wide range of topics including; wood carving effects, tool choices, sanding options, colour effects and other wood finishes.

Wolfgang kicked off the evening with a demonstration of wood carving and the preparation required to start the process off. He talked about the tools he used, including both manual tools and power based tools. He then demonstrated the tools to show the different type of effects that can be achieved with each. He personally preferred the manual tools and the fact that when correctly done there is no need for any sanding to be undertaken, he believed was a great benefit.

Throughout the demonstration Wolfgang answered questions from club members and gave practical advice about tool sharpening. He then talked about sanding and his personal preference for using professional products such as Abrenet.

He showed the meeting the tools and accessories he found most useful, including his palm sander and soft sanding pads he used for curved surfaces. He advised the meeting to buy the best tools they could afford, as he had discovered that it only “hurts” once and you end up with something that may last you a lifetime.

Wolfgang started the second part of the evening with an unfinished piece from a previous demonstration. He mounted the piece in a chuck and trued it up. Whilst doing this he spoke about the types of cuts he was using and the less experienced club members found this level of detail to be very useful. The wood used was ash, so it was plain and very light coloured which made it perfect to demonstrate colouring. Firstly, due to time constraints, he sprayed the wood black. This took only minutes to dry. Wolfgang then added some colour (green) and polished off the excess. This had the effect of highlighting the growth rings in the wood with a faint green hue. The overall impact of black with green highlights was very effective. Wolfgang talked about the specific products he used and where to buy them from. Throughout the evening Wolfgang was generous with his help and advice and everyone was grateful for the self-deprecating way he told us about some of errors and mistakes he had made along the woodturning road, to help the rest of us to avoid them if at all possible. Hot sanding of wood is a no-no!

He finished the evening with two further short demonstrations.

He showed us the technique for adding metallic colour to a platter and talked about the importance to only use the best quality brushes to apply the finish. The place to get the right quality was any artist material stockist.

Finally, he talked about the fact that even the smallest piece of very expensive hardwoods can be utilized.  He turned a door cupboard knob from a small offcut of ebony. Showing the meeting a glue chucking technique for small pieces of wood and demonstrating a number of woodturning cuts. He completed the demonstration with a simple wax finish on the knob, perfect!

A thoroughly entertaining and informative evening was had by all. Thank you, Wolfgang.